Site map|Online message

Home > Reference > Fittings standard data

Reference

ASME B36.10M 2004 Welded and Seamless Wrought Steel Pipe

times   2015-11-02

ASME B36.10M 2004 Welded and Seamless Wrought Steel Pipe


SCOPE


This Standard covers the standardization of dimensions of welded and seamless wrought steel pipe for high or low temperatures and pressures. The word pipe is used, as distinguished from tube, to apply to tubular products of dimensions commonly used for pipeline and piping systems. Pipe NPS 12 (DN 300) and smaller have outside diameters numerically larger than their corresponding sizes. In contrast, the outside diameters of tubes are numerically identical to the size number for all sizes.


SIZE


The size of all pipe is identified by the nominal pipe size. The manufacture of pipe NPS 1⁄8 (DN 6) to NPS 12 (DN 300), inclusive, is based on a standardized outside diameter (OD). This OD was originally selected so that pipe with a standard OD and having a wall thickness that was typical of the period would have an inside diameter (ID) approximately equal to the nominal size. Although there is no such relation between the existing standard thickness — OD and nominal size — these nominal sizes and standard ODs continue in use as “standard”. The manufacture of pipe NPS 14 (DN 350) and larger proceeds on the basis of an OD corresponding to the nominal size.


MATERIALS


The dimensional standards for pipe described here are for products covered in ASTM specifications.

Copyright@Hebei HAIHAO high-pressure pipe flanges Group Co., Ltd.